Wiki
RE-ENGINEERING
RE-EXPLORING
EXPANDING
Technical knowledges & human souvenirs about of analogue film practise resulting from the project RE MI
RE-ENGINEERING
RE-EXPLORING
EXPANDING
This was part of BAINS ARGENTIQUES ~ Nantes's International Film Labs Meeting - 4 » 9 july, 2016
Prepare the negative with leader at the tail, because it is tail-first printing
Negative and raw filmstock are bi-packed in the Bolex camera, emulsion facing each other.
Negative needs to be head out/ emulsion up/ sprocketholes towards you.
Raw filmstock needs to have emulsion in/ sprocketholes towards you.
On a winder, wind the 2 together, filling the spool 'like a cup of tea', leaving a little space. Depending on filmstock, in dark or in red light.
Wind camera
Set speed to 12 fps
Load Bolex, making sure to align the sprocketholes of both films.
Bolex as a contactprinter 1 from FILMVERKSTADEN on Vimeo.
Check image and printstock, by choosing T and opening the shutter.
Now it is time to expose. Exposure is critical, so you will need to test!
Bounce light off a white wall, making a 90 degree angle with the camera without lens. Holding camera around 20 cm from wall. Orw expose by pointing at the sky
Bolex as a contactprinter 2 from FILMVERKSTADEN on Vimeo.
If you need less light, change the speed or the shutter.
After exposure, separate the films. Process your film as usual.